A complete radio solution offering the most secure form of staff protection available today. The solution is formed by three key elements:-

• Mobiles
• Location Beacons
• Control / Display Equipment 

Mobiles

All people requiring protection would carry a Staff Protection Mobile. This mobile can transmit an alarm giving the user’s location in the event of an incident.  The mobile can also receive alarm and location information. This means that no one should have to carry two units.

An alarm can be generated in 4 ways: -

• By pressing the Large Red Alarm Button
• By pulling out the Rip-Cord (optional)
• Automatically via a tilt mechanism (optional) should the staff member be incapacitated. (However, this option would not normally be recommended for use in a secure unit.)
• By pressing two buttons simultaneously to send a non-emergency 'assist' call.

Control / Display Unit

All alarms are displayed and acknowledged by this versatile controller.  Upon receipt of an alarm the controller will bleep and display the exact location of the alarm as well as the type of alarm and who the alarm is from.

It is also possible to add radio Nursecall units to this system enabling a fully featured integrated solution.

Location Beacons

Location beacons are strategically installed around a site to provide acurate location identification. The beacons constantly transmit a unique identity which is picked up by a mobile that is nearby.  The transmission is a low power radio signal which means that a user can carry a mobile even inside a pocket, confident in the knowledge that the signal will get through. This also means that beacons can be placed outside a building a will not be affected by the weather or direct sunlight.  Range of coverage can be adjusted but typically only needs to cover entrance and exit points around a site.

In association with

[Products] [About Us] [Nursecall] [Paging] [Cardiocall] [DECT] [Staff Protection] [Staff Attack] [Lone Worker] [SMS / GPS]

http://www.SearchEngineOptimising.com